HP Tuners MPVI3: How To Get a Stock File - OCDiesel

HP Tuners MPVI3: How To Get a Stock File

Before you start!

When you read a vehicle, you are transferring calibration information from the control module(s) in your vehicle to VCM Editor. The read process will automatically detect the presence of relevant VCMS in the vehicle and read them all in sequence. The various status messages and the progress bar give information about the current state of the read.

It is not possible to harm any of the vehicle's control modules during the read process. If communication is lost, the program will automatically reset the module. It will then prompt you to correct the problem and/or try again.

 

What you need:

HP Tuners interface device (MPVI3)

 

Read Procedure

1. Connect your HP Tuners interface device to a laptop with VCM Suite installed. Then, connect the device to the vehicle's OBD-II diagnostic port.

2. If VCM Scanner is already open, close it before proceeding.

3. Open or Re-Open VCM Editor.

4. If a tune file is open, close it by selecting File > Close in the menu bar.

5. Turn the vehicle ignition to the ON (or RUN) position, but do not start the engine. NOTE: Some vehicles require special procedures to be put in the correct state.

6. Make sure the doors are closed and all accessories are turned off.
CAUTION: Do not use any vehicle accessories, including the door locking mechanism while the vehicle is being read.

7. In VCM Editor, select Flash > Read Vehicle.

HP Tuners Stock Read step 7

8. The Vehicle Reader window appears. Wait 10 to 15 seconds.

9. Click the Read button.

HP Tuners Stock Read step 9

10. Allow VCM Editor to read the vehicle controllers until the status bar indicates the read is complete. NOTE: During the read, the instrument panel may briefly display all sorts of indicators anderror messages and some accessories may appear to turn on and off randomly. This is normal. NOTE: For vehicles with multiple VCMS (for example: LS2 A4 vehicles), there is a 15-secondpause between reading each module.

11. Turn off the ignition and unplug the interface cable.

12. The file will automatically open in VCM Editor.

13. If this is the initial read of the stock controller, we strongly recommend that you save (and backup) the file before any modifications are made. You may wish to restore your vehicle to the stock tune at a later date.

 

What's next?

Once you have successfully got the read you are ready to get a tune file! 

Leave a comment

Please note, comments need to be approved before they are published.